Ferm BJM1009

I bought this machine because I was looking for a not too expensive machine that I could experiment with. Another option was to rent, but then I would have spent almost the same for a day as if I bought this machine myself. The machine works excellently, the saw cuts are nicely consistent in depth and width and the dust extraction is above expectations. Of course there are some lesser points, such as the switch is not very smooth, so it takes some effort to switch on the machine. Also, not all parts are nicely finished, but it does work, you just need a little more attention when operating. However, these are especially points that you notice when you compare machines that cost at least five times that.

The supplied dust bag works perfectly in horizontal position (for which the device is made), however to shorten a laminate floor, to remove the pressure from an expanded floor, use the device in vertical position. In this case, it is better to connect a vacuum cleaner to avoid accumulation.

The device has a strong tendency to pull to the left due to the direction of rotation of the blade, hold it firmly.

Complete product and can certainly be used to take the pressure off a laminate floor. (creates approximately 16mm space from the wall/plinth). Note: stick felt pads on the device to prevent streaks on the laminate floor.

Bought this machine as an interior builder. I always work with the lammello at work. Which I use several times every day. I also wanted to have a lammello for myself. Only the real ones are almost 10x more expensive than this one. So that fell off

The choice I made to I am happy to buy this. You should take it a little easier than the official lammello. But that doesn't matter. The only downside is that there is some play in the valve. If you keep it horizontal. (Expand) There is also no fixed points for 45 degrees. But this is never used.

I would recommend this machine to people who need it every once in a while