The most common errors of Bosch and Siemens washer dryer combinations

With error code E:36, there's a problem with the water drain of the appliance. There might be a blockage in the drain tube, hose, or pump. Make sure there are no bends in the drain hose first. Then, check if there's something stuck in the drain hose by gently removing and cleaning it. Lastly, you can check the drain pump. That's at the bottom of the washer dryer combination. You can read how to remove the pump cover and casing in the manual of your appliance.

Do you see error code E:35 on the display? You have a leak. Turn the appliance off, and close the water supply completely. Next, contact the customer service of the place where you bought the appliance. Did the warranty of the washer dryer combination expire? Contact Bosch or Siemens directly.

Error code H:95 indicates there's no water during the drying phase. This water is needed to rinse the condenser. You can solve it by cleaning the filter in the supply hose. Completely close the water supply and gently remove the supply hose from the appliance. Clean the filter at the end of the hose with a brush or soft toothbrush. In the end, you can place the hose back and open the water supply.

If you have the H:32 error code, the drum isn't balanced. The appliance will stop spinning, because the drum shakes too much. You can easily solve this by distributing your laundry more evenly. You can pause the cycle and wait until you can open the door. Untangle your laundry and distribute it evenly over the drum. Continue your cycle.

Doesn't the error code go away? Unplug the connector from the socket for 30 minutes and restart the cycle. Unfortunately, you can't solve all errors yourself. If your washer dryer combination isn't covered by the warranty anymore, you can use our Coolblue repair service. Our technicians will help you find a quick and safe solution at your home